Home / RC Helicopter Electronic Speed Controls / E-flite 30-Amp Pro Switch-Mode BEC Brushless ESC V2: EC3

E-flite 30-Amp Pro Switch-Mode BEC Brushless ESC V2: EC3

Quantity
ADD TO CART
BUY IT NOW
  • Detail

    Overview

    The E-flite® 30-Amp Pro Switch-mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

    Key Features

    • Up to 30 amps continuous current with proper air flow and 35 amps burst current (15 seconds)
    • 3.5A continuous current, 5V Switch-Mode BEC Circuit
    • Stronger BEC for support of most 3-axis stabilization systems
    • Drive up to 7 analog or 6 digital standard-size servos with the BEC
    • 3- to 4-cell Li-Po, 9- to 12-cell Ni-MH/Ni-Cd input voltage
    • Programmable motor braking
    • Safe power-arm mode prevents accidental starts
    • Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V) or 74% of battery starting voltage
    • Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
    • Programmable soft start for helis and airplanes
    • Auto motor shut down if signal is lost or there is interference
    • Programmable timing - 5 user-selectable ranges for use with a large variety of brushless motors
    • Pre-wired connectors—E-flite EC3™ connector on battery input and 3.5mm gold bullet connectors on motor output leads

    Product Specs

    Amperage
    30A
    BEC Voltage
    3.5A continuous
    Brakes
    Yes
    Connector Type
    EC3
    Input Voltage
    10.8?14.8V
    Maximum Burst Current
    35A
    Maximum Continuous Current
    30A
    Output Connector
    3.5mm Bullet
    Part Type
    Electronics
    Programmable
    Yes
  • Customer Reviews
    No comments
BACK